New resin storage (at last)

[sci_starborne]

I’ve been holding off buying more casting supplies, because I was in dire need of a better way of storing them. The old fridge-freezer I’d been using was simply too small, and particularly in this damp weather I want somewhere dry and warm to be able to store the supplies where they’ll last longer.

Two weeks ago I managed to grab a large commercial display fridge off ebay, and after a lot of problems with the local garage and our van we managed to collect it.

Well actually we got within 0.7miles of collecting it before the van fuel-pump failed (which we’d repeatedly asked the garage to check, but they knew best & instead changed the distributor cap & leads. Not going back there now.). Thankfully the seller brought it down to our van in their car, so we got to get towed home with it in the back.

Today I finally managed to get it moved into the workshop.

It’s a big square insulated box. The glass door is a small concern, but I suppose it’ll get me to keep the place tidier.

I got the wiring tidied up and moved around. The refrigeration still works, and I’ll be seeing if it’s possible to use it as a dehumidifier. As you can see in the quick cameraphone pic, the oil-filled radiaitor currently takes up a lot of space, so I’ll be seeing it I can improve that, possibly by changing it for a filament heater (though I’m concerned about fire risk). Will be adding a couple of fixed temperature sensors at some point to trigger the fan and try and keep the temp evenly distributed.

There’s a hole at the top that also needs plugging, where the neon lamp used to be. Silly bit of design, but easier enough to work around.

Tomorrow I start work on moving everything I shifted to the other side of the workshop back again, so I can actually use the place and get on with the current orders.

Mirrored from The blog-hub for Peter "Sci" Turpin.