Twitter Updates for 22-10-2010

[sci_starborne]

• 1week to have everything completed for Expo deliveries and RBW. Due to building work before RBW, cannot assume will be able to use workshop. 15:06:28, 2010-10-22
• Fuck fuck fuck fuck. 15:06:53, 2010-10-22
• Sometimes you gotta accept these risks. http://ballerinamafia.net/index.php?pid=20101011 15:25:23, 2010-10-22
• Am in the workshop. My motor's barely ticking over tho. 16:47:14, 2010-10-22
• 2hrs later, the biggest bits of wood have been dismantled. Woo~ 18:40:33, 2010-10-22
• Recessed with real-wood caps. Hard to find the screws. Plus wood a little swollen, so some holes too small now. Some splits. 18:42:27, 2010-10-22
• With carefull planning, cutting and biscuiting, probably enough for most of a fancy desk. Eventually. Back-burner once all tidied away. 18:43:41, 2010-10-22
• The incorect mill chuck is badly machined on the inside of the collar too! Collet clamping off-centere as a result! 21:18:01, 2010-10-22
• Will have to put the collar on the lathe to fix it. Very annoying. 21:19:31, 2010-10-22
• A well-stocked workshop is useful, because it's hard to procrastinate when all the tools are on-hand. 21:58:29, 2010-10-22
• Securing nut/collar is almost turned down perfect now. Collet seats right, but dislike untidy edge. 21:59:12, 2010-10-22
• Okay, can't do any more without making a special boring tool. 22:08:28, 2010-10-22
• 0.35mm at nut, 0.2mm at chuck, 0.1mm at bearing. Putting chuck in lathe tailstock tho, alignment is perfect. 22:31:58, 2010-10-22
• Millhead bearings possibly? No, would just be offset, not eccentric. Must be the MT2 collet holder. Looks like a homemade part. 22:34:57, 2010-10-22
• Spent longer fixing tools today than using them. 23:31:48, 2010-10-22
• Have at least discovered roughly how millhead goes together. To dismantle will need bigger mallet. 23:33:36, 2010-10-22
• Time to go in and shower. Will reassemble mill head tomorrow. 23:35:56, 2010-10-22
• Chest's tight again. 23:36:22, 2010-10-22

Mirrored from The blog-hub for Peter "Sci" Turpin.